Galaxy Audio DS-SP36 - Manual (Page 20)

19
High Shelving Filter: As an example if we want to set a high shelving filter within EQ-1 then the PM2
encoder has to be rotated counter-clockwise until the desired High Shelving filter say -6HiSh appears on
the screen, the GAIN at say +3dB using the PM3 encoder and the Low Cut Frequency at say 1.00KHz with
the NAV/PM1 encoder.
The EQ sub-menu screen will show the following
Note: Once the desired High Shelving filter is selected, the PM3 can then be used to select the desired
GAIN and when the GAIN is set at a value different from 0.0dB, then the filter type cannot be changed until
this GAIN is returned to 0.0dB.
Once in the High Shelving Filter's edit screen all the filter's parameters can be modified using the
“NAV/PM1”, “PM2” and “PM3” encoders for editing the Filter's Low Cut Frequency, Filter's Order and Gain.
The Lo Cut Frequency of the High Shelving Filter can be edited using the “NAV/PM1” encoder, the Filter's
Order can be adjusted by the “PM2” encoder and the Gain the “PM3” encoder:
“Lo Cut Frequency”: the selectable frequencies range is from 20Hz to 20kHz in steps of 1/24 of an Octave
and can be adjusted by rotating the “NAV/PM1” encoder.
“High Shelving Order”: the selectable High Shelving Filter's range can be selected between the
1st (Lo-1st.) and the 2nd (Lo-2nd.) one.
“Gain”: the selectable range of the Gain is from -15dB to +15dB in steps of 0.5 dB and can be adjusted by
rotating the “PM3” encoder.
Note1 : Once the desired options have been selected using the 3 encoders, they are automatically saved
as current and stored in the DS-SP36 system status once leaving the page.
Note2 : To exit this page, push the “ESC” button.
● Menu “Output 1/2/3/4/5/6” Output Channels Editing [access by pushing the
“1/2/3/4/5/6” buttons]
From the “Default Screen”, it is possible to access the “Output Channel” menu by pressing the “1” or “2”or
“3” or “4” or “5” or “6” button. Once pressed, the related blue “EDIT” LED will turn ON.
The Sub-Menus pages can now be scrolled through by rotating clockwise and counter-clockwise the
“NAV/PM1” encoder.
For parameter editing it is necessary to press ENTER and an arrow will appear on the left of the screen
“ -> ”. Then use the “PM2” and “PM3” encoders for selecting and setting the parameter values. On some
parameters that have three independent values, you will also need to use the PM1 encoder, for example for
the filter’s parameter setting.
Note: All parameter editing can be done using the “NAV/PM1”, “PM2”, and “PM3” encoders and the current
shown value of the selected option is AUTOMATICALLY loaded during the encoders’ use and stored as the
current value once leaving the page.
HPF sub-menu – from this sub-menu it is possible to set the Output Channels High Pass Filter (HPF).
The following is an example of a HPF sub-menu screen with the filter set at 24dB Linkwitz/Riley on
Output1... using the name “High” (see later for assigning a Name to the outputs):
Input-A EQ-1
–› 1.00KHz -6HiSh + 3.0dB