Alpine 7909 - Manual (Page 8)

CONTROLS AND INDIiCATORS IN CASE OF DIFFICULTY
RADIO MODE
Unable to receive
stations.
No Antenna or open
connection in cable.
Make sure the antenna is
properly connected: replace the
antenna or cable if necessary.
Unable to tune station
in the Seek mode. You are in a weak signal
area. Make sure the tuner is in the
DX mode.
If the area you are in is
not known to be a weak
signal area, the antenna
may not be grounded and
connected properly.
Check your antenna connec­
tions; make sure the antenna
is properly grounded at its
mounting location.
The antenna may not be
the proper length. Make sure the antenna is fully
extended; if broken replace
the antenna with a new one.
Broadcast is noisy. The antenna is not the
proper length. Extend the antenna fully;
replace it if it is broken.
The antenna is poorly
grounded. Make sure the antenna is
grounded properly at its
mounting location.
The station you are
listening to is weak or
susceptible to multipath
interference.
Press the MONO button to
place the tuner into the Mono
mode until you change stations
or the signal improves.
CD MODE
CD insertion not
possible. There is a CD already in
the transport. Eject the CD in the transport
and remove it.
The CD is being improp­
erly inserted.
Make sure the CD is being
inserted per instruction in the
Owner's Manual.
Unable to Fast-
Forward or Rewind;
Fast-Forward or
Rewind is very slow. The CD has been dam­
aged. Eject the CD and discard;
using a damaged CD in your
unit can cause damage to the
transport.
Sound skips due to
vibration.
Sound skips without
vibration.
Improper mounting. Disc is
very dirty. Disc has scratches.
Dirty or scratched disc.
Securely re-mount the unit.
Clean the disc. Change the disc.
Clean the disc: damaged
discs should be replaced.
25