Repeat (one), Scan, M.i.x. (random play) – Alpine 7909 User Manual

Page 16: Cds (cd straight), Operation, Cd changer operation, Initial system turn-on, Direct disc access, Repeat (one/aii), To repeat a single track

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

5. When the pickup reaches the end of the disc, it automatically returns to the

beginning. Playback will then start from the beginning of the disc.

REPEAT (One)

This feature allows you to continuously play back a single track.

1. Press the REPEAT button ®. The REPEAT indicator @ shows in the display.

2. The musical track shown in the display will be played back repeatedly.
3. To defeat the Repeat function, press the REPEAT button ® a second time.

SCAN

Press the SCAN button ® and the player will play back the first 10 seconds of each

track in succession. This function is useful in searching for a specific program ahead
on a disc. Press the SCAN button ® a second time to deactivate this function.

M.I.X. (Random Play)
Depress the M.I.X. button ® while in the CD mode and the musical tracks will be

played back in a random sequence generated by the microprocessor. After all the

tracks on the disc have been played back once, the player will begin a new random
sequence. Press the M.I.X. button a second time to deactivate this function.

CDS (CD Straight)

Press the CDS button 0 to activate the CDS mode. The CDS indicator ® will light.

To prevent the introduction of noise into the signal, the tone and balance circuits are

bypassed. This ensures that only the quietest, most dynamic and natural sound will
be heard. Press the CDS button 0 a second time to deactivate this function.

Note: When using the 7909 as a controller for the Alpine CD changer, the CDS

functions only with the internal CD player.

OPERATION

The following instructions apply only to systems that incorporate the Alpine CHM-
S601 or CHA-S604 CD changer (option) with the 7909.

Initial System Turn-On

When operating the system for the first time after installation or after the vehicle’s

battery has been disconnected and reconnected, press the Reset switch © with a
mechanical pencil or other pointed object.

Turn the unit on and access the CD Changer mode by pressing the DISC button ®
for more than 2 seconds. The CHANGER indicator ® shows in the display.

Direct Disc Access
1. Press one of the Direct Disc Access buttons ® to select from discs 1 - 6 . The

indicator in that button lights. The track number and the elapsed time will appear
in the display.

2. Press the M.S./CD UP 0 or DN 0 button for musical track selection.

REPEAT (One/AII)

This feature allows you to continuously repeat a single track or one entire disc.

To Repeat a Single Track

1. Locate the music track of your choice using the M.S./CD UP 0 or DN 0 button.

track will be played back repeatedly.

3. To stop repeat play, press the REPEAT button 0 twice. The indicator switches

from "REPEAT" to "ALL REPEAT" and the illumination will be off.

To Repeat an Entire Disc

1. While playing a disc, press the REPEAT button

indicator 0 is displayed.

2. The disc will be played back repeatedly.
3. To stop repeat play, press the REPEAT button (

will be off.

until the "ALL REPEAT"

once. The indicator illumination

For other operations for the CHM-S601 or CHA-S604 CD Changer, refer to the CD
OPERATION section on pages 14 through 16.

If no sound is heard during operating, proceed the next procedures.
1. Set the volume to minimum.