Alpine 7909 - Manual (Page 13)

CONNECTiONS OPERATION
3. To tune to higher frequencies, press the M.S./CD button on the top (UP)
tune to lower frequencies, press this same button on the bottom (DowN)
To
Auto SEEK Tuning
1. Press the TUNE button dD until the SEEK indicator appears in the display.
2. Select the tuning band with the BAND button
3. Press the UP @ or DowN ® button. The unit automatically tunes to the next
higher or lower frequency and locks on that station.
Manual Memory Preset
Follow the instructions below to program stations into preset memory.
1. Select the tuning band (FM1, FM2, or AM) with the BAND button
2. Tune in your desired station by manual or Auto SEEK tuning.
3. Press and hold any Preset button @ for more than two seconds. The tuned
frequency in the Digital Display (D will begin to blink. Press that button a second
time while the indicator is blinking (within five seconds).
Your selected station will be placed into that preset location and the indicator will
light.
Note: If a preset memory has already been programmed in that location, it will be
cleared and the new station will replace the old preset.
4
Auto MEMOry Preset
1. Press the TUNE button dj) to light up the A. MEMO indicator
2. Select the desired tuning band (FM1, FM2 or AM) with the BAND button
3. Press the UP @ or DN @ button. The tuner will automatically seek the six
strongest stations in each band and memorize them in order of the signal
strength. These stations are automatically placed in the preset memory with the
strongest station in Preset No. 1 and the 6th strongest station in Preset No. 6.
When seeking stations, the tuner first seeks in the local tuning mode. If less than
6 stations are memorized, the tuner seeks again in the distance (DX) mode.
4. After finishing the Auto MEMOry Preset, the tuner goes to the station placed in
preset memory No. 1. If no stations are memorized, it returns to the original
station you were listening to before the Auto MEMOry Preset procedure began.
When the auto memory presetting is completed, the A. MEMO indicator @ will
disappear and the SEEK indicator @ will appear.
Preset Tuning
After the preset stations have been memorized, you can tune in your desired station
(within the band displayed) with one touch of a button.
1. Select the tuning band (FM1, FM2 or AM) with the BAND button ®.
2. Press any one of the Preset buttons ® and the indicator in that button will light.
3. The frequency of the station placed in the selected preset location will appear in
the display.
13