Philips 54XP43C/37 - Manual (Page 40)

S etting Y our R emote T o W ork VCR s , C onverters - S earch
y our TV remote can be set to
work your VCR or Cable
Converter by what is called the
SEARCH method.
If the REM OTE CODE” num ber
method shown in the previous
section did not set your rem ote tQ
work your VCR or Converter, then
follow the easy steps listed below.
Please read through steps 1-4
before beginning,
CBEOIN)
Press the POWER button on
the VCR or Converter to turn the
unit ON.
Stand at least six feet away
from the front of the VCR or
Converter.
Point the remote toward the unit.
HOLD DOWN the SURF and
the desired System (VCR or
CBL-Converter) buttons at the
same time. KEEP HOLDING
BUTTONS DOWN.
Watch the Channel Indicator
on the unit.
Channel Numbers will SCAN UP
when the unit has been identified.
This may take up to two minutes.
Release the SURF and System
(VCR or CBL) buttons as soon
as channel numbers start to scan
up. The code has been identified
and the remote is ready to operate
with the VCR or Converter.
S m a r i H i ; i . i >
Remember, a minute or
S two can seem very long, but
the code should be located within
two minutes.
Don't let the VCR or Converter
scan up more than five channels.
The remote may pass up the right
code and another two minute
search cycle will have to be
repeated.
If no channel change happens
within two minutes, repeat steps 1-
4. Should a channel change still
not occur, the remote will not
work with the desired unit.
CABLE CONVERTER
40