Philips VR 588 - Manual (Page 7)

20 STOP B / T button
• Stops the tape. (•>?. 14)
• Moves down the cursor when using
the menus. (4-P.U)
21 CH (channel) a / t button
Before using this button, press VCR or
TV.
• After pressing VCR, changes the
channels on the VCR. Release at a
desired channel.
For some Philips TV only:
• After pressing TV, changes the
channels on the TV. Release at a
desired channel.
22 VOL (volume) a / ▼ buttons
For some Philips TV only:
Changes the TV volume.
Release at desired volume.
23 CLEAR button
Erases unwanted timer programmes.
(>)-P.18)
24 AUDIO/MUTE button
For some Philips TV only:
Turns off the TV sound.
To insert the batteries:
1
Remove the battery compartment lid
fixim the bottom of the remote
control.
Install two batteries —^R6(SUM-
3)/AA — matching polarity
indicated inside the battery
compartment ■
Note:
This remote control and batteries are
supplied accessories.
Check to make sure they are included.
Also, check "Specifications" to see what
other accessories are included.
I-CAUTION-
Replace the lid.
On Battery Replacement
Do not mix old and new batteries.
(Also never mix alkaline batteries
with manganese batteries.)
Rear Panel
3 ANT. (antenna) IN (input)
terminal (from Antenna)
Connect your antenna or Cable to this
terminal. (>)-P.9)
4 RF OUT (output) terminal (to
TV)
Use the supplied RF coaxial cable to
connect this terminal on the TV. (AP.9)
1 AC (alternating current)
power cord
Connect the AC power cord to an AC
outlet.
2 AVI IN/OUT terminal
(SCART)
For connecting to the SCART terminal
(21-pin SCART connector) on TV or
another VCR. (>)-P.9. P.19.)
— 7 —