Philips STU 801/25R - Manual (Page 23)

8) Name
The default programme ¡dent can be altered with this option (up to a maximum of six digits). The
▲ and ▼ keys select alphas or numerics and pressing SETUP will move the cursor to the next digit and
so on. The STATUS key will move the cursor back. Programme 90 has been designated the TEST
programme and cannot be renamed.
Adding New Programmes
To add new programmes it will be necessary to first locate them. This can most easily be done using the
FREQUENCY SCAN MODE which is enabled by pressing the SETUP key followed by the 3 key. The timer
LED will flash as the receiver scans for programmes on the polarity you were last viewing. When a picture
is present, the scan speed will automatically decrease allowing the user time to press the SETUP key and
halt the scan. The picture will have the Customization menu superimposed on it. Continue as described
in the Modifying Existing Programmes section to fine tune this new programme. If the scan is notterminated
while a picture is present, normal scan speed will be resumed until the next signal is encountered. To
quickly end a scan, press the NORM key. To scan for programmes on the opposite polarity, simply press
the AUDIO key while scanning. This will toggle the polarity on each press.
Fitting of External Decoders
The receiver has the capability of accepting two external decoders via the DECODER SCART socket on
the rear panel of the receiver. If an external decoder correctly controls pin 8 or 18 of the DECODER SCART
socket, the receiver will switch automatically to this input otherwise it will be necessary to set the AV source
setting to EXT V and the decoder option to either EXT 1 or EXT 2.
Fitting of MAC Decoders
If it is required to connect a MAC Receiver into the system then use the DECODER SCART socket and
press AUX/0 on the handset to select the MAC Receiver. It is recommended that all other programmes not
using an external decoder have the AV source option set to INT.
NOTE: If two pieces of equipment are to be used i.e. a MAC Receiver and a PAL Decoder, the MAC
Receiver must be connected to EXT 1 (PINS 8, 19 and 20). Contact your dealer for a suitable lead.
. Customization Menu_____ ___ ___________ __________________j
21