Installation guide for the instaltatlon engin – Philips STU 801/25R User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Tuning In the TV/VCR to the Satellite Receiver using the aerial socket

Having connected the receiver to the dish aeriai, TV (A.) and/or VCR (B.), switch on ali the equipment.
Seiect a programme on your TV/VCR you want to aiiocate to sateiiite programmes and bring the receiver
out of standby, if a picture is not visibie, move the SETUP/NORM switch on the rear panei to SETUP. If

two vertical bars (the test signal) are not visible then adjust either the TV/VCR to channel 38 or the channel
adjustment screw CH on the receiver rear panel to the same frequency as the TV/VCR. Once the two
vertical bars are visible move the SETUP/NORM switch to NORM. If installation is correct a satellite picture
should be visible. It may be necessary to fine tune the TV for the sharpest possible picture.

Installation Guide for the Instaltatlon Engin^^^