Flyzone FLZA4032 - Manual (Page 6)

6
❏
3. Insert a 2.5x10mm screw into the hole at the aft end of
the horizontal stabilizer and tighten it until snug.
❏
4. Center the elevators so they are in the neutral position
with the horizontal stabilizer. Tighten the screw in the elevator
screw lock connector.
❏
5. Insert the vertical fi n into the opening in the fuselage.
Guide the rudder actuator wire into the slot in the rudder.
❏
6. Secure the vertical fi n in place with a 2.5x10mm screw.
❏
7. Fit the servo wires for the wing through the cutout in the
fuselage as shown.
❏
8. Connect the servo leads to the receiver. The leads are
labeled as to which numbered channel slots they need to be
installed into.