Flyzone FLZA4032 - Manual (Page 5)

5
6. Charging time depends on the level of discharge of the
battery and if the battery cells were unbalanced.
LED SCHEME Use this table to determine charge action.
RED LED
OFF
OFF
Solid ON
Solid ON
Flashing
GREEN LED
Solid ON
Flashing
Solid ON
OFF
Flashing
No battery is connected
Conditioning battery
Battery charging
Charge complete
ERROR *
ACTION
Possible sources of battery error may include a highly unbalanced
pack, charger timed out, or one cell of the pack which is low voltage.
In the case of a battery error, please remove the battery pack from
the charger and inspect it carefully for swelling or any other damage,
such as broken wires. *
Battery Charging Precautions
● Be careful to avoid overcharging the battery. Only use a LiPo
approved charger. Never use a NiCd/NiMH peak charger.
● Remember to check the temperature of the battery during
the charge. The battery should not get hot. If it does, unplug
the battery from the charger.
● Charge the battery at a maximum charge rate of 1.8 amps.
A higher charge rate will cause the battery to get hot.
● Never place the battery on combustible material or leave it
unattended while charging.
● Never charge the battery in the plane.
● We recommend that a balancing charger be used to charge
the battery. A properly cared for battery will last a long time. If
the battery pack is continually charged without balancing the
individual cells, the life of the battery pack will be shortened.
Battery Recycling
ATTENTION: The Corsair is powered by a rechargeable battery.
At the end of the battery’s useful life, under various state and
local laws, it may be illegal to dispose of the battery into the
municipal waste system. Check with your local solid waste
offi cials for details in your area for recycling options or proper
disposal. We encourage contacting your local recycling center
for more information.
Assemble the Corsair
❏
1. Slide the elevator pushrod out of the aft end of the
fuselage and connect the Z-bend on the wire into the outer
hole of the elevator control horn.
❏
2. Guide the elevator pushrod into the screw-lock connector
on the elevator servo arm as you slide the horizontal stabilizer
into place.