FloAire FAV - Manual (Page 40)

Revision 12 – 11.19.2013
START-UP CHECKLIST
WARNING!!
-The Start-Up must be completed after all field wiring and air balancing has been completed
-The Start-Up must be completed by a qualified HVAC technician
-The Start-Up Check list must be faxed into the Service Department to validate the product warranty
JOB INFORMATION TECHNICIAN INFORMATION
Job Name Service Company
Address Address
City City
State State
Zip Zip
Phone Number Phone Number
Fax Number Fax Number
Contact Contact
Purchase Date Start-Up Date
Refer to the start-up procedure in this manual to complete this section.
Name Plate and Unit Information Field Measured Information
Model Number Motor Voltage
Serial Number Motor Amperage*
Motor Volts Low Speed RPM **
Motor Hertz High Speed RPM
Motor Phase Low Speed Differential Pressure ** in. w.c.
Motor FLA High Speed Differential Pressure in. w.c.
Motor HP Pilot Flame Signal VDC
Blower Pulley Low Fire Flame Signal VDC
Motor Pulley High Fire Flame Signal VDC
Belt Number Gas Type Natural
Gas Type Propane
Min. Btu/Hr High Fire Inlet Gas Pressure in. w.c.
Max. Btu/Hr Low Fire Manifold Gas Pressure in. w.c.
High Fire Manifold Gas Pressure in. w.c.
Temperature Control Discharge
Space
Airflow Direction Correct
Incorrect
* If measured amps exceed the FLA rating on the nameplate, fan RPM must be reduced to decrease the
measured amps below the nameplate FLA rating.
**Low speed readings used on variable air volume units.
Factory Service Department
Phone: 866-784-6900
Fax: 919-554-9374