Flintec FT-13 - Manual (Page 54)

FT-13 Technical Manual, Rev. 1.40 March 2013 Page 54 of 56
A PPENDIX 7: P ARAMETER
’
S D EFAULT T ABLE
Parameter Factory defaults
0-- Interface
00- Serial Interface 1
0 Data format 2 = Printer
1 Baud rate 3 = 9600
2 Handshake 0 = Disable
3 Address 0
4 Data length and parity 0 = 8 bit, no parity
5 Checksum 1 = Enable
02- Serial Interface 2
20 Data format 0 = Disable
21 Baud rate 3 = 9600
22 Handshake 0 = Disable
23 Address 0
24 Mode 0 = RS232C
25 Data length and parity 0 = 8 bit, no parity
03- Ethernet / Profibus
30 Ethernet data format 0 = Disable
31 Ethernet address 0
32 Profibus data format 0 = 32-bit integer
33 Profibus address 0
34 CANopen data format 0 = 32-bit integer
35 CANopen address 0
36 ProfiNet data format 0 = 32-bit integer
04- Printer
41 Date + Time 0 = don‟t print
1-- Configuration
12- Filter
120 Filter 6
14- Entries
140 Date entry dd.mm.yy
141 Time entry hh.mm
2-- Scale Parameters
20- Set up
200 Approved 0 = No
201 Increased indication 0 = With x10 key
203 Zero with key 1 = ± %2
204 Auto Zero Tracking 1 = ± 0.1e
205 Tare 1 = With Tare Key
206 Motion detector 1 = ± 0,5e
21- Scale Build
212 Capacity (2) / d(2) 6 kg / 0.001 kg
3-- Calibration / Adjustment
30- Calibration
301 Calibration
31- Adjustment
310 Zero adjustment
311 Span adjustment
312 Span adjustment under load
Parameter Factory defaults
5-- Filling
50-
Filling Parameters
51-
500 Filling programme Programme 0
501 Preact correction factor 30%
502 Preact correction frequency 1
503 Preact correction limit
100%
504 Coarse feed. control delay 0.7 s
505 Fine feeding control delay 0.7 s
506 Maximum settling time 1.0 s (delay 0.0 s)
507 Jogging time 0.0 s
508 Filling time 0 = Disable
509 Maximum weight 3000
50A Start / Reset keys 0 = Disable
50b Filling Quantity control 0
50C Filling type 1
50d Fine feeding time at start 0 (=starts with coarse f.)
50E Zeroing period 250 s
50F Zeroing delay 3.0 s
510 Indication in filling process 0 (= increasing)
59- Filling Performance Test
590 Coarse feed test
591 Fine feed test
8-- Metrological Data
80- Legal Metrology
800 Calibration counter
9-- Diagnostics
90- Tests
900 Key Pad test
901 Serial interface 1 test
902 Digital input test
903 Digital output test
904 mV indication
91- Serial numbers
910 FT-13 serial no.
911 Option 1 serial no.
912 Option 2 serial no.
913 Option 3 serial no.
914 A XX.--
915 A --.YY
99- Print Parameters
990 All parameters
991 Load default parameters