Flintec FT-13 - Manual (Page 18)

FT-13 Technical Manual, Rev. 1.40 March 2013 Page 18 of 56
7.3 Filling Programmes
7.3.1 Programme 0: Open Container Filling
F T -1 3 F T -1 3
Application:
Open container filling
Big bag filling
Operation:
The filling starts with activating the start input
and is executed as 2-speed or 3-speed
above surface container filling
The process ends when the filled container is
removed from the platfrom
Filling can be done as Gross or Net
Process Parameters Description
+ + + + When FT- 13 is in the “Ready” status (the top LED in the LED
bar is “on” ) press the keys shown on the left sequentially.
“d_FıLL“ means a start delay.
When the start input is activated, the filling starts after the
start delay. This period can be set by the keypad from 0.0 s
to 9.9 s. The delay parameter may be helpful for some
special processes.
“tArE ” is the minimum tare value.
The filling can start if the weight of the container is higher
than this value. It can be entered by numeric keys.
“tArE ” is the maximum tare value.
Filling can start if the weight of the container is lower than this
value. It can be entered by numeric keys.
“ZEro_r” is the zero range.
At the end of the filling, when the container is removed from
the platform, the weight has to be in the zero range for ending
the filling process.
“Gr-NET” defines if the filling will be done as Gross or Net.
0 = Gross
1 = Net
Exit
Process Messages Description
This message is shown on the display during the start delay.
This message is shown at the end of the filling.
This message and the weight are shown alternately until the
container is removed from the platform.
tArE XXXXX
d_FıLL
X.X
StArt
FULL XXXXX
tArE XXXXX
XXXXX
Gr-NEt X
ZEro_r