DLE 30 - Manual (Page 16)

16
Engine Troubleshooting
If your engine fails to start after the preceding starting procedures
please check the following.
Symptom Diagnosis Fix
Engine
does not
fire
Ignition battery
voltage low Charge or
replace battery
Engine
starts,
then rpm
increases
till engine
cuts out
Fuel not reaching
engine Check for:
a) fuel in tank
b) fuel tubing
cut, blocked,
or kinked
c) carburetor
clogged
Battery wires faulty
or loose Replace wires or
Re-connect/check
connections
Faulty spark plug
or not firing Replace spark plug
or check for spark *
Engine flooded Remove plug,
disconnect fuel
line, rotate prop
to remove fuel
* This can be done by removing the spark plug from the cylinder
of the engine, inserting the plug onto the plug cap, and contacting
the plug to the outside of the crankcase. Have an assistant turn the
engine over while checking this and be sure to have the spark plug
fi rmly plugged into the ignition wire. Warning: The high voltage
from the ignition can cause bodily harm, especially when checking
for spark in this manner.