Digilent 210-161P - Manual (Page 2)

Digilent, Inc. FX2 MIB Reference Manual
www.digilentinc.com
www.digilentinc.com page 2 of 4
Copyright Digilent, Inc. All rights reserved. Other product and company names mentioned may be trademarks of their respective owners.
The forty general-purpose I/O signals from the
FX2 connector are brought out to connector
J7. These signals are labeled IO1-IO40. See
Table 1 for a description of the relationship
between FX2 connector pins and signal names
on J7. The remaining signals from the FX2
connector are brought out to connectors J8,
J9, J11, and J12. See Table 1 for a description
of the relationship between FX2 connector pins
and connectors J8 and J9 signal names.
In addition to the FX2 connector signals,
connector J11 and J12 also provide access to
the power and ground busses.
Pmod Connectors
Digilent Pmods provide various peripheral
functions. These can be as simple as buttons
or switches for inputs and LEDs for outputs, or
as complex as graphical LCD display panels,
accelerometers, and keypads.
All Digilent Pmods use either a six-wire
interface or a twelve-wire interface. The six-
wire interface provides four I/O signals, power,
and ground. The twelve-wire interface provides
eight I/O signals, two powers, and two
grounds. The signal definitions for the I/O
signals as well as the voltage requirements for
the power supply depend on the specific
module.
The FX2 MIB provides four twelve-pin and two
six-pin Pmod connectors.
The twelve-pin connector provides access
such that the top set of four pins are the odd
labeled signals while the bottom set are even
labeled signals. See Table 2.
The signals for Pmod connectors J1-J6 are
brought out to connector J7. These signals are
labeled IO1-IO40.
Each Pmod connector has an associated
power select jumper. The power select jumper
for J1 is JP1, and so on. These jumpers are
used to select one of the two power busses on
the FX2 MIB to provide power to the power
supply pin on a Pmod plugged into that
connector position. Placing a shorting block in
the 3V3 position provides VCC power to the
Pmod. Placing a shorting block in the 5V0
position provides VCCFX2 power to the Pmod.
Place a shorting block so that it hangs off of
the center pin only to disconnect power to the
Pmod.
FPGA Configuration
The FX2 MIB provides JTAG access via
unloaded jumper J9. Given that the jumper
JP7 labeled JTSEL is shorted, this jumper
allows a connected board to be programmed
via a JTAG cable.
See Table 1 for a description of the
relationship between the FX2 connector pins
and the connections on the JTAG jumper J9.
Clocks
The FX2 MIB provides an oscillator clock input
to a system board via socket connector IC1.
This socket can be used to input a clock signal
to a system board when an external oscillator
is placed on it. It will then output a clock signal
on the CLKIO pin of the FX2 connector.
The unloaded jumper J8 provides access to all
possible clock signals into and out of the FX2
MIB. This includes the signal CLKIO from the
external oscillator socket connector as well as
CLKIO and CLKOUT signals directly from the
FX2 connector.
See Table1 for more details.