D.A.S. Audio DSP-26 USB - Manual (Page 36)

34
MASTER
Enables transmission of all control changes to other devices on the same MIDI channel for example
to run two DSP-26 in parallel for stereo applications.
THRU
Allows the throughput of data received at the MIDI in socket to the MIDI out .
PCPORT
This mode allows the USB port on the rear of the DSP-26 to be used to perform MIDI systems
exclusive dumps and to control other DSP-26.
This Utility is used to transfer Program information between DSP-26 units of the same model as well
as to any MIDI Sysex ( systems exclusive)capable sequencer or computer. Attach a MIDI cable from
the MIDI out of the sending unit to the MIDI in of the receiving unit.
Pressing the button on the sending unit will display the prompt screen below.
A MIDI sysex message is now sent out that prompts the receiving unit that an incoming MIDI dump
will occur. A receiving DSP-26 unit should display a message asking to allow an incoming dump.
If you do not want the receiving unit to have its memories overwritten then press the button on the
receiving unit to change the "Allow Dump ?" message to "No". The receiving unit will return to normal
operation and ignore any incoming Program information.
Pressing
at any time will return the sending unit to the Utilities mode.
Pressing on the sending unit performs the dump.
9.3 MIDI Systems Exclusive Dump
PREV/NEXT
SAVE/ENTER
SETUP
MIDI MODE
MASTER
SETUP
MIDI MODE
THRU
SETUP
MIDI MODE
PCPORT
SETUP *
MIDI DUMP NO
MIDI DUMP ?
ENTER TO CONFIRM
OPERATION
Manual del usuario/ User´s manual DSP-26