D.A.S. Audio DSP-26 USB - Manual (Page 28)

26
Press to reconfigure the DSP-26 to the desired set-up.
Pressing any other keys will cancel the operation and return you to the previous configuration.
Switching to Mono configuration forces all Outputs to be routed from Input A.
Crossover frequencies are set to OUT, i.e. Full range operation.
Delay linking defaults to off.
Stereo Linking is unavailable.
Band Names will be changed to 'Band 1' through 'Band 6'.
Output 1,3 and 5 are routed from Input A.
Output 2,4 and 6 are routed from Input B.
All delay linking defaults to off.
Stereo Link will be switched on.
Band Names will be set to 1'low', 2'mid', 3'high', 4'low', 5'mid', 'high' for Outputs 1~6 respectively.
The Low and High crossover frequencies are set to the following default values:
If the DSP-26 is used for a stereo 2 way only system, Outputs 3-6 would be used with Low(3-4) and
High(5-6). This allows subwoofers to be added late on Output 1 and 2 without rewiring existing
systems.
Enter
2.2 Mono mode
2.3 2 Channel * 3 way mode
CHANGE TO MONO ?
ENTER TO CONFIRM
UTILITIES
CONFIG 2CH 3WAY
L L
M
H
M
H
Stereo Link
Stereo Link
Stereo Link
Output 1 Output 2
Output 5 Output 6
Output 3 Output 4
Delay
Link
Delay
Link
Delay
Link
Delay
Link
OPERATION
Manual del usuario/ User´s manual DSP-26