D.A.S. Audio Variant Series Systems Guide - Manual (Page 9)

7
AXC-ZT
M8x35 DIN912
AXC-V25
Pole Mount
20º
EN
The accessory can also be used as a
support for up to two units on a pole
mount accessory, on top of one unit.
To do so the accessory is to be used
upside-down and a special pole mount adaptor
must be fixed to it by means of two
M8x35
DIN912 screws, nuts and washers. A 10º splay
angle is recommended in order to achieve a 20º
vertical coverage.
AXC-V25
variant 25A
variant 18A
AXC-V25
When a pair of hook clamps are attached to
the ceiling mount accessory, it can be fixed to a
truss structure such as the one shown in the
picture below:
variant S uide ystems G