D.A.S. Audio Variant Series Systems Guide - Manual (Page 11)

9
M 8x35 DIN912
AXC-V112
AXC-ZT
EN
The accessory can also be used as
a support for up two unit on a pole
mount accessory, on top of one unit. To
do so the accessory is to be used
upside-down and a special pole mount adaptor
must be fixed to it by means of two
M8x35
DIN912 screws, nuts and washers. A 15º splay
angle is recommended in order to achieve a 30º
vertical coverage.
AXC-V112
variant 112A
variant18A
AXC-V112
When a pair of hook clamps ( ) are
attached to the ceiling mount accessory, it can be
fixed to a truss structure such as the one shown in
the picture below:
AXC-AT
variant S uide ystems G