D.A.S. Audio Variant Series Systems Guide User Manual

Page 8

System installation using the ceiling support AXC-V25

M8X30 DIN965

AXC-V25

Rubber washer

M8x35 DIN 912

Grower (lock) washer

Metal washer

Three different washers must be used along

the M8x35 DIN912 screws and placed in the
following

order-

grower

(lock)

washer,

metal

washer and rubber washer.

In order to hang the rest of the boxes the

captive rigging hardware and safety pins will be
used, and the procedures described on the 4.3
paragraph of this manual will be followed. The
picture below shows three

units

hanging from the ceiling.

variant 25A

Before connecting the first box to the ceiling

mount accessory the two M8x30 DIN965 screws
must be removed from the

and

replaced by two M8x35 DIN912.

variant 25A

The

units can be set up as a long

array of more than four enclosures (as explained
above) or as a small array of 2, 3 or 4 units. In the
latter

case

the

highly

resistant

grid

accessory is not necessary. Instead the
ceiling mount accessory can be used to hang a
cluster of up to four units.

First attach the ceiling mount accessory to the

ceiling or a beam. Before doing so be sure that the
load bearing capability of these elements is
enough. The

will be attached to the ceiling

by means of six nº 10 rawlplugs

and six

7 x 40

mm screws.

variant 25A

AX-V25

AXC-V25

AX-V25

variant S

uide

ystems G