D.A.S. Audio Convert 15A series Rigging - Manual (Page 13)

13 Manual de Colgado / convert 15A series / Rigging Manual
VERTICAL ARRAY (‘-A’ versions)
This mounting type convert1560A or
convert1590A are required. Some AXA-CV15 and
one
AX-CONVERT15B for one lift motor. In case of
using two lift motors, a PICK UP AX-CONVERT15 will
be needed.
Firstly, place two enclosures like in Figure 14,
one above the other on a flat surface.
Remove the screws indicated in Figure 14.
Following, screw the AXA-CV15 with the
included screws in the same position shown in
Figure 15.
The final result is shown in Figure 16.
PICK UP AX-CONVERT15
(WLL=300 kgf)
Mounting type
Figure 14
Figure 15
Figure 16
AX-CONVERT15B
(WLL=300 kgf)
AXA-CV15
(4 screws included)
Be conscious that rigging must be performed
by highly skilled workers, with an adequate
knowledge of the equipment and fittings to use.
Workers must also know the local safety
regulations. User is responsible to ensure that
sound
rigging systems (including rigging
accessories) meet state and local regulations in
force.