Crosman MAR177 - Manual (Page 7)

7
11. MAR177 Conversion Kit removal (Upper)
When handling the MAR177 Conversion Kit follow warnings engraved on
MAR177 Conversion Kit. Do not depress the TRIGGER block located on underside of upper. TRIG-
GER is engraved on the block. Keep hands clear of TRIGGER block at all times. Failure to follow
these instructions may result in serious injury or death.
a. Before removal
1. Depressurize (refer to 6A & 6B)
2. Ensure firearm lower safety is in the on or safe position
3. Ensure the MAR177 Conversion Kit is unloaded
4. Ensure the rotary magazine is removed
b. Remove take down and pivot pins
12. Maintaining Your Airgun
• Crosman recommends the use of silicone chamber oil only.
• Apply Crosman silicone chamber oil (Crosman Model
RMCOIL) on the barrel o-ring every 3 months or 500 shots.
Apply with a cotton swab as shown in (Fig. 14).
• Do not use any petroleum based lubricants.
Explosion Danger. Do not introduce petroleum based products into the high pres-
sure reservoir, or it may cause an explosion. Failure to follow these instruction may result in serious
injury or death.
DO NOT MODIFY OR ALTER YOUR AIRGUN. Attempts to modify the airgun in any way inconsistent with
this manual may make your airgun unsafe to use, cause serious injury or death, and will void the warranty.
If you drop your airgun, visually inspect looking for obvious damage. If anything seems changed, for
example, you notice a shorter or weaker trigger pull, this may mean that part in your airgun has become
worn out or broken. Under these circumstances, call Crosman Customer service or one of its Authorized
Service Stations for assistance before using your airgun again.
13. Reviewing Safety
• Never point the airgun at any person or at anything you do not intend to shoot.
• Always treat the airgun as though it is loaded and with the same respect you would a firearm.
• Always aim in a SAFE DIRECTION. Always keep the muzzle of the airgun pointed in a SAFE DIRECTION.
• Always keep the airgun on safe until you are ready to shoot.
• Always check to see if the airgun is “ON SAFE” (see Firearm manual) and unloaded when getting it
from another person or from storage.
• Always keep your finger off the trigger and out of the trigger guard until ready to shoot.
• You and others with you should always wear shooting glasses to protect your eyes.
• Your reading or prescription glasses are not safety glasses, make sure you wear shooting glasses
over your regular glasses.
• Use .177 caliber (4.5mm) pellets only in your MAR177. NEVER reuse ammunition.
• Do not shoot at hard surfaces or at the surface of water. The pellet may bounce off or ricochet and
hit someone or something you had not intended to hit.
• Place the target in a location that will be safe should the backstop fail.
• Your backstop should be checked for wear before and after each use. All backstops are subject to wear
and will eventually fail. Replace your backstop if the surface is worn or damaged or if a ricochet occurs.
• Do not attempt to disassemble or tamper with your airgun. Use an Authorized Service Station. Using
unauthorized repair centers or modifying the function of your airgun in any way may be unsafe and
will void your warranty.
• Store airgun in a secure location. REMEMBER- THERE IS NO SAFETY DEVICE WHEN THE MAR177
Conversion Kit IS REMOVED FROM THE LOWER.
• Before you store your airgun, remove the rotary magazine, make sure there is no pellet in the cham-
ber and make sure the gun is uncocked (see section 6) and depressurize the gun.
• NEVER store this airgun charged with air when not in use.
This airgun conversion kit has been classified as an adult airgun and is recommended for adult use only.
Because it is considered to be a special purpose airgun conversion kit, it is exempt from specific types of
trigger pull, safety mechanism and drop tests.
Fig 14