Comtrol VS3000S - Manual (Page 9)

Installation Overview 9
Introduction
Installation Overview
The following figure illustrates the InterChangeVS 3000 hardware
and software installation procedure.
Note: The following procedure assumes that the ISDN line is already
installed and operational. See the Working with the Phone
Company section for more information.
To install VS-Link the
Install the VS3000 using the
Installing the Hardware section.
Connect an RJ45 ISDN* cable between the
VS3000 and ISDN line phone jack or NT1
first time, use the software
installation section for your
operating system.
To update VS-Link or add
additional VS3000 units,
remove the existing VS-Link.
Re-install VS-Link using the
software installation section
for your operating system.
Connect the appropriate Ethernet* cable
between the VS3000 and the network.
Terminating Unit (depending on country).
While ISDN and Ethernet cables may appear to be identical, they are
not interchangeable. Make sure you are using the correct cable(s) in
the correct locations. *