COMP Cams 5491 Sprint Car Front Drive Kit for LS Engines - Manual (Page 8)

COMP Cams ®
3406 Democrat Rd.
Memphis, TN 38118
Phone: 901.795.2400
Part #COMP4-158
Revised 8/10/12
Toll Free: 1.800.999.0853
www.compcams.com
Figure 5: Front Cover Bolts
Step 14: Install the M8 sealing washer [35] and an M8 nylon locking nut [34] onto the
M8x1.25x75mm stud that was previously threaded into the rear idler mounting plate. Torque to 27 ft-
lbs.
Step 15: Slide the water pump adapter [11] onto the crank snout ensuring that it aligns with the
keyway.
Step 16: Install water pump using the previously installed studs along with four M8 nylon locking nuts
[34] and M8 plain washers [36]. Torque to 27 ft-lbs.
Step 17: Install the oil pump using customer supplied bolts Note: oil pump mounting bolts are
5/16"-18 UNC threads.
Step 18: Install the magneto using the magneto clamp [14] and two M8X1.25x25mm hex head bolts
[32]. Note: the magneto must be a Ford 351W style. Standard cam height blocks require the
supplied crescent shaped magneto spacer to be placed under the magneto clamp during assembly.
Note: Ford distributors rotate counter-clockwise. Be sure to install your plug wires using the LS
firing order (1-8-7-2-6-5-4-3) in a counter-clockwise direction.
M8x1.25x30mm [25] (B6)
M8x1.25x20mm
Countersunk [29] (B10)
M8x1.25x30mm [26] (B6)
M8x1.25x25mm [33] (B14)
M8x1.25x30mm [25] (B6)
M8x1.25x30mm [26] (B6)
M8x1.25x25mm [33] (B14)