Toshiba KV-7168A - Manual (Page 29)

ALARM RECORDING
!S)ii:rr
If an alarm condition arises, the alarm function operates with an alarm input signal.
Operation at Alarm Input
When there is an alarm during recording, recording pause or stop modes, the VCR automatically goes into alarm recording mode.
The VCR can be programmed to record in the following time modes during alarm recording: A2, A6, A12, At 8, A24.
Alarm input
Recording
Recording pause
Stop
A2. A6. A12: A18,
i I A2^it^rsi v
Recording
Recording pause
Stop
Alarm Recording
When there is an alarm input in the STOP mode, a slight delay will occur in start of the alarm recording.
When the pause mode continues for 10 minutes the VCR goes to the stop mode. This ooours in order to protect the video heads
and tape. While in pause mode, the video head is constantly tracing the same location.
Alarm recording will not operate from power off mode and timer power off mode.
Event Recording
If event recording is desired, set the VCR’s recording mode to L01, L02 or L03. In order to accomplish this press the time mode
button until TOT’, “L02’’ or T03’ is shown.
If there is no alarm input present when in T01T “L02" or T03 ’ mode, the VCR automatically forwards 2 fields with recording every
appointed time
Warning at Alarm Recording
When an alarm signal is input, the buzzer sounds and the alarm display on the VCR DISPLAY lights.
Alarm display lights and then blinks when alarm recording is finished.
r'
Changes to a display of A2, .A6, A12, A18 or A24, 8/28/96 AOi
1/:30:13 A 2--
The day of the week disp ay
changes to the alarm number
during alarm recording.
Changes to a display of A2,
A6, A12, At8 or A2A. Turn off the BUZZER switch to stop the buzzer.
To stop the alarm display blinking, press the ALARM button to change the counter display to the alarm counter and then press
the RESET button.
Alarm Recall Display
Check the alarm input information on the ALARM RECALL screen.
CLOCK ADJUST
SETUn
UiSf'LAY MOUh
PROGRAM
ALARM REC.ALL
TTMF DATF SEARCH
END=ED]SPLAV]
ALARM RLCALL
0:14:12
19:14:12
ALl 8/19/96M0N 20;35;Q9
AL2 a/ 7/96VJED 21:36:16
AL3 7/2B/96THU
ALA 7/12/96FRI
AL6 6/20/96IHU 23:14:10
AL6 4/ l/9ht1UN 21:07:13
AL7 --/--/---------
IS“ 4/ 1/96M0N 21:07:13
HENU-[DlS=^LAy]
29
At 1ST, the first (oldest) alarm input information is displayed.
At ALl, the latest alarm input information is displayed.
When more than seven items are input, the old information is erased and the new information is stored in the memory.
To erase the alarm recall contents, press the ALARM button to change the counter display to alarm counter and press the
RESET button.