Toshiba MA-215-10 SERIES - Manual (Page 24)

PERCENT DISCOUNT
(1) To discount from the sub-total:
----» [ST] -> [%-] -►---... to discount by the preset %~ rate
-- -* [ST] I RATE I -4 [%-] -- ... to discount by a manual rate
0.01-99.99
(2) To discount from a Department or PLU item:
[DEPT] —
— [PLU] -
-♦ [%-] -- ••• to discount by the preset %- rate
-- [DEPT] -|
I RATE I -*■ [%-] ------ ... to discount by a manual rate
-- ^ [PLU] -I 0.01-99.99
NOTE: Use the [.] key if the rate contains the decimal point,
ex.) To enter 4.5%: operate 4 -♦ [.] 5
PERCENT CHARGE
This operates the same as in the PERCENT DISCOUNT operations above,
except that the [%+] key is used instead of the [%-] key.
ITEM CORRECT
Use [ITEM CORR] after each of the sequences listed below.
DEPARTMENT ENTRY (page 16)
PLU ENTRY (page 16) -------
REPEAT ENTRY (page 16) -------
QUANTITY EXTENSION (page 16)
SPLIT PACKAGE PRICE (page 17)
DOLLAR DISCOUNT (page 17)-----
PERCENT DISCOUNT (this page)”
PERCENT CHARGE (this page)-
RECEIVED-ON-ACCOUNT Item: [AMOUNT 1[R/A]
PAID-OUT Item: |AMOUNT j[PO] ------------
[ITEM CORR]
NOTES: 1. When [ITEM CORR] is depressed after a QUANTITY EXTENSION
sequence, the entire product resulted from the multiplication
will be deleted.
2. When [ITEM CORR] is depressed after a REPEAT ENTRY sequence,
only the last item of the repeated will be deleted.
3. A department or PLU sequence with TAX STATUS modification may
also be deleted by [ITEM CORR], but any sequence modified with
[RTN MDSE] can be deleted with [ITEM CORR].
-18-