Toshiba TEC MA-1040-100 Series - Manual (Page 41)

PAPER ROLL REPLACEMENT AND OTHER MAINTENANCE OPERATIONS
Fig. 2
15 to 20cm
Fig. 3
INSTALLING THE RECEIPT PAPER
1. Turn the Mode Lock to the "REG"
position with the power on.
2. Remove the Paper Cover, and remove
the Journal Winding Reel (Fig. 1).
3. Hold a new paper roll in the
direction as shown in Fig. 2 so.that
the paper end will be fed from the
bottom.
4. Fold the paper end firmly as shown in
Fig. 3 to ease the insertion.
5. Place the paper roll in the
outer-side holder of the two roll
holders (Fig. 4).
6. Insert the paper end into the Receipt
Inlet, feed the paper in while
pressing down the Free Lever (or feed
the paper in while pressing the [RF]
key). (Fig. 5)
7. When all the folded portion comes
out, tear off the unnecessary part
with an appropriate end length
remaining (approx. 5cm or 2 inches).
(Fig. 6)
8. Go on to INSTALLING THE JOURNAL PAPER
steps in necessary, or go on to Step
9 below if not.
9. Attach the Paper Cover. Meanwhile,
the paper end must be seen outside
the cover.
10. Press the [C] key to clear the
paper-end condition, and depress the
[NS] key to issue a receipt to check
if the paper has properly been set.
Fig. 6