Toshiba TEC MA-1040-100 Series - Manual (Page 33)

READ (X) AND RESET (Z) REPORTS
The following table shows the key operation to take each report. The "X" and
"Z" reports have exactly the same print content if both are available, except
that:
1. The "X” report allows to read the totals but not clear memories, while
the "Z” report allow to read the totals and at the same time all the
resettable memories will be cleared when the report has been issued.
2. The symbol "X" is printed as the header of a "X” report, while "Z" is
printed on a "Z" report, to indicate the type of report.
3. A reset count is printed near the bottom of a "Z" report only.
TABLE OF OPERATIONS FOR X AND Z REPORTS
REPORT NAME KEY OPERATION
SAMPLE
PAGE
* AUTO READ
* AUTO RESET
Mode Lock: X ,
Mode Lock: Z
36
ZONE PLU READ
ZONE PLU RESET
Mode Lock: X n i„ ^ .. tit n r. j 1
j ^ , „ ] Zone-start PLU Code
Mode Lock: Z '—--- ---'
[X]
Zone-end PLU Code
I
[PLU]
38
ALL PLU READ
ALL PLU RESET
Mode Lock: X ^ r .
Mode Lock: Z ^ ^ ^
38
* INDIVIDUAL CLERK READ
* INDIVIDUAL CLERK RESET
Mode Lock: X n _ ^ ^
„ , , , „ ] Set the Clerk Key of the
Mode Lock: Z ■ j i i ..
required clerk to ON,
1 [AT/TL]
39
* IN-DRAWER READ Mode Lock: X [#] Cor [#/NS] 40
HOURLY READ
HOURLY RESET “o': l ::": z '
40
* GT READ
* GT RESET
(Accumulated Sales Data
to be reset on a weekly
or monthly basis but
not daily.)
Tot": z 1
41
NOTES: 1) The cash drawer will open on the depression of the final key of the
KEY OPERATION for the reports marked with
2) No clerk key is necessary to issue any of the reports except
INDIVIDUAL CLERK READ/RESET reports.
3) Refer to the report samples on the following pages. The descriptor
of each line may vary according to the programmed data of each
store, and some of the counter or total 1ines may not be printed by
print/non-print options.
4) As for the PRESET DATA VERIFICATION operations and print samples
which are also available in the "X" mode, see the "VERIFICATION OF
PROGRAMMED DATA" in the PROGRAMMING MANUAL separately issued.
- 35 -