Suspending, Retry, Incomplete ending – Toshiba TEC MA-1900 User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

EOl-11006
SUSPENDING
This is to be operated for the purpose of suspending an in-line service being executed, when any
terminals remain unserviced, and of going on to a “RETRY”, “INCOMPLETE ENDING”, or
“CANCEL” operation as the next step.
OPERATION ON MASTER TERMINAL:
(Same Lock positions as the in-line job being performed)
Depress [ITEM CORR] or [VOID] until the key-in tone is generated.
DESCRIPTION:
The SUSPENDING operation is allowed any time during an in-line service procedure.
If suspending by the [ITEM CORR] or [VOID] key is accepted, the Master terminal’s display
indicates the number of unserviced terminals and the last service-attempted terminal’s
Register/ID No., and now a “RETRY” or “INCOMPLETE ENDING” operation can be
selected as the next step.
RETRY
This is to be operated for the purpose of re-attempting the In-line service that has been stopped
due to “TIME OUT” or that has just been suspended by “SUSPENDING” operation.
OPERATION ON MASTER TERMINAL:
(Same Lock positions as the in-line job being performed)
Depress [AT/TL].
DESCRIPTION:
The in-tine service will again be attempted to the unserviced terminals. This operation is
possible any number of times after a “TIME OUT” condition or a “SUSPENDING” operation
as long as any terminals remain unserviced.
INCOMPLETE ENDING
This is to be operated to abandon services to unservIced terminals, and ends the in-line service
with the services to service-completed terminals only.
OPERATION MASTER TERMINAL:
(Same Lock positions as the in-line job being performed)
Depress [NS].
DESCRIPTION:
If an in-line service being executed does not seem to end normally due perhaps to some
abnormal status of any Satellite Terminals after “TIME OUT”, “SUSPENDING”, and/or
“RETRY” operations, the [NS] key can be depressed to end the in-line service with only the
service-completed terminals serviced and the unserviced terminals remaining unserviced. In
case of In-line X or Z Report Collection sequences, reports of only the service-completed
terminals will be issued.
- 2 5 -