Toshiba TEC MA-1900 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11006
( [X] = [@/FOR], [#] = [#/CID]
\
GT Lock; RTR [OPEN] = [LC OPEN] = (PR OPEN] J
TABLE OF IN-LINE REPORT OPERATIONS (continued^
Report
Header
Report Name
Mode
Lock
Key Operation
DEPARTMENT AND PLU ABC
(Process Reports)
ANALYSIS REPORTS (Read only)
X21
• Best Selling Departments in
Quantity: Daily
X
1 r#l
i|Endino Rank No.|)
FAT/TLl
GT
X
101 (Follow from [#] above)
X21
• Best Selling PLUs in Quantity
(Link Department Designation): Daily only
X
1
[#1
->(iDEPTl for |Code| tDP#D) -►
ijEndino Rank No.|1
TPLUl
X22
• Best Selling Departments in
Amount: Daily
X
2
r#l
-► ((Ending Rank No.[)
fAT/TLl
GT
X
102 (Follow from [#] above)
X22
• Best Selling PLUs in Amount
(Link
Department Designation): Daily only
X
2 (#1
-^(fDEPT]
for |Code|
TDP#!))
->
((Endina Rank No.|l
FPLUl
X23
• Worst Selling Departments in
Quantity: Daily
X
3 [#1
-> f|Endina Rank
No.|) [AT/TLl
GT
X
103 (Follow from [#] above)
X23
• Worst Selling PLUs in Quantity
(Link Department Designation): Daily only
X
3 [#]
-^(rOEPT]
(or |Code|
iDP#l))
((Ending Rank No.()
fPLUl
X24
• Worst Selling Departments in
Amount: Daily
X
4
r#l
-» ((Ending Rank No.|)
[AT/TLl
GT
X
104 (Follow from (#] above)
X24
• Worst Selling PLUs in Amount
(Link Department Designation): Daily only
X
4 r#l -KfDEPTJ (or |Code| tDP#lrt -»
((Endina Rank No.|)
[PLU]
NOTES 1. When the operation is precede with “([OPEN])”, it indicates that the report data will only be
collected and stored into the Consolidated Memory of the Master Terminal but not print out
This operation is useful in taking a “Process Report” thereafter but not requiring the print out
of that report itself.
2.
When the “Process Report” is marked, the report can only be taken after taking another
report which consolidates the corresponding data to be based on. Also refer to NOTE 1
above.
3.
As for other miscellaneous operations available in RTR/X or RTR/Z mode, see the last
chapter of this manual.
- 20 -