KORG Concert Korg Digital Piano C-150 - Manual (Page 31)

|C4
6. Attach the Piano.
Rest the piano on the rear of the side panel tops,
lift it up slightly and slide it toward the front of
the side panels.
The rubber feet on the bottom of the piano will
make contact with the brackets on the side pan­
els and cause it to stop.
Fasten the two piano mounting screws (8) to the
bottom of the piano.
floor, the Pedáis wilt be unstable
and the sound may be affected.
2. Assembling the Stand
7 . Connect the pedal cord and fasten it in place.
The top of the rear panel is
open to improve the acoustics
Plug the connector at the
end of the pedal cord into
the PEDAL jack located on
the piano's lower board. Be
sure that the connector is
oriented correctiy.
Fasten the pedal cord
with the cord holder.
Post-assembly Check
□
□
Are there any parts left over?
If there are any parts remaining, check each of
the part positions shown in the illustration to find
where they are missing from.
Check the mounting screws for any looseness.
Itil:
Caution
Cautions when Moving
Please disconnect the piano from the stand and move
them separately. After moving, reconnect according
to these instructions. Also, be careful of the follow­
ing points when moving the piano.
• Wind up the power cord in a small bundle. If it
is left to dangle, the cord could catch on some
other object and be cut, and could cause short cir­
cuits or other damage.
• Be careful that the pedal cord doesn’t catch on a
door knob or other object during moving.
Loose Screws After
if period of time passes after assembly, the screws
holding the parts of the stand together may become
loose, causing the stand to wobble. If this happen,
re-tighten each screw.
Disossembly
To disassemble the piano and the stand assembly, fol­
low the assembly procedure in reverse order. After
disassembly, keep the screws and other parts so that
they do not get lost.
To disconnect the pedal cord, pull on the cord con­
nector while pressing the little tab (O) on the con­
nector. Do not exert too much force on the cord, since
it could break.
3М