KORG Concert Korg Digital Piano C-150 - Manual (Page 30)

2« Assembling the Stand
Use the following procedure to assemble your ST-350
or ST-150. The assembly procedure for both models
is the same; the only external difference is the num­
ber of pedals. The illustrations below are based on
the appearance of the ST-350 (three pedals).
Caution
Two or more people are required to assemble the
piano unit.
When attaching the piano to the stand, be careful
not to let go of it.
Make sure you do not mistaken the type or direc­
tion of each part. Follow the assembly procedures
carefully during assembly.
If too much force is applied to the front before fas­
tening it with the mounting screws, the piano
could fall off the stand.
O
You will need a Phillips head screw driver to
tighten the screws.
2, Open the box and take out the parts.
Make sure ail the parts shown below are included
in the box.
Piano
r~T
Side Panei
(Left) ®
Rear Panel ®
Side Panel
Pedal Box @
Packed in a vinyl bag
Assembly Screws ® x 4
(M6X50)
Adjuster (D
Screws @ X 10
(W3.SX1$)
Piano Mounting
Screws ® X 2
(M6X14) Cord Holder ® x 1
30
For assembly, you must place the back of the »
stand on a smooth surface such as the floor, as
shown in the diagram below. Assemble the Side |
Panel (Left) (T) and the Side Panel (Right) (5) to |
the Pedal Box (|) using the 4 assembly screws |
Pull out the Pedal Cord.
Screw the Adjuster © into the Pedal
Box (3) until it is all the way in.
4. Attach 3 Screws (7) in the Pedal Box
partially tightening them.
as shown.
Do not tighten the screws until
5. Assemble the Rear Panel (4). j
Tighten the Screws (7) from the previous step into]
the bottom of the Rear Panel (4). Fasten the Side]
Panels to the Rear Panel (T) using the 6 Screws (7)1
Use the last 1 remaining Screw to attach the Cord]
Holder (9).
Install the Rear Panel with
the decorator surface facing
toward the front.
Insert the Rear Panel ^
Fasten the piano cord
with the Cord Holders (|).