Numeric keys, Decimal point key, Amount key ... [amt – Toshiba TEC MA-230 User Manual
Page 13: Listing capacity open key ... [lc open
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7 8 9
4 5 6
1 2 3
0 00
NUMERIC KEYS
These are used to enter numeric values such as amount
, quantity, or
code number.
Depressing the [00] key once is the same as depressing the [0] key
twice consecutively.
The maximum listing capacity is 8 digits for inputting a numeric value
only, and 7 digits for registration except that a non-add # may be
entered in maximum 8 digits.
DECIMAL POINT KEY
[ . ]
This key is used, as part of the numeric keys, to designate the
position of the decimal point when entering a percent rate or a
quantity with a decimal portion. For example, to enter
0 . 5 % , index
0
-*-[. ] >5, or [. ] ♦5,
When entering a price or amount such as
$ 0 . 2 5 , just index 2 + 5 . In
this case, depression of the [.] key is not necessary an will cause an
error.
AMT
AMOUNT KEY
... [AMT]
This key is used to enter an amount or price for an open PLU,
to the description for the ”[PLU]" key on page 7.
Refer
PR
OPEN
PRESET OPEN KEY
... [PR OPEN]
This key is used to modify the status of preset department keys. When
the [PR OPEN] is depressed prior to depressing a preset department key
(either before or after the numeric entry), the preset department key
is reversed to non-preset and allows amount entry through the numeric
keyboard.
If a perset department is entered with a price through the numeric
keyboard using the [PR OPEN] key in the above mentioned manner, no
repeat operation for the same price entry is then possible for that
department key.
The [PR OPEN] key can not be used with the [PLU] key.
LC
OPEN
LISTING CAPACITY OPEN KEY
... [LC OPEN]
This key is used to release the listing capacity on each Department.
To operate, depress the [LC OPEN] key before depressing the department
key (either before or after the numeric entry).
By depressing the [LC OPEN] key, the HALC (High Amount Listing
Capacity) will be released to allow a numeric entry with two further
digits,
In order to allow a numeric entry exceeding the values defined above,
the Mode Lock must be turned to the "MGR" position by the store
manager.