Kenwood KRF-V5560D - Manual (Page 33)

In case of difficulty
Amplifier
- - Sf»ptoin Cans# '' ......... .<1 Remedy -
No sound from the speakers. • The speaker cords are disconnected.
• VOLUME IS set to the minimum position.
• MUTE IS ON
• The SPEAKERS switches are set to OFF.
• Connect them properly referring to "Connect­
ing the speakers" -OS
• Adjust the volume to a proper level.
• Turn OFF the MUTE. -!2a]
• Set the SPEAKERS switch to ON. -Cg]
The standby indicator blinks and sound is
not output.
• Speaker cords are short-circuited. • Turn the power off. eliminate the short-circuit­
ing, then turn on the power again.
Sound is not output from one of the speak­
ers. • The speaker cord is disconnected. •Connect it properly referring to "Connecting
the speakers". ~l3£l
Sound is not output from the surround
speakers and / or the center speaker, or their
sound is very small.
• The surround speaker cords and/or the center
speaker cord is disconnected.
• A surround mode has not been engaged.
• The surround and/or center volume controls
are set to the minimum level.
• Connect it properly referring to "Connecting
the speakers". -QJ)
• Select a surround mode.
• Adjust the speaker levels using the test tone.
A humming noise is generated when the
PHONO input selector is selected.
• The audio cord from the record player is not
connected to the PHONO jacks.
• The record player is not grounded
• Insert the audio cord plugs securely Into the
PHONO jacks,
• Connect the grounding wire to the GND termi­
nal on the rear panel.
When playing a Dolby Digital source signal
using a DVD player, the sound is cut off soon
after it starts.
• There are many possible causes for this prob­
lem, depending on the type of DVD player
used.
• Set the input mode to digital manual before
starting playback of the Dolby Digital source.
No sound is produced during playback from
a DVD player.
• The input mode is set to digital manual. • Press the INPUT MODE key to select to digital
auto mode, -tj]
A video source cannot be recorded normally. • The software is copy-guarded. • Copy-guarded video software cannot be re­
corded.
Tuner
Symptom T „, , t«: 1 fj . -, ■ ■ ' ■ . _ ........................................... TiliilP Remedy
Radio stations cannot be received. • No antenna is connected.
• The broadcast band is not set properly,
•The frequency of the desired station is not
tuned
• Connect an antenna. -132
• Set the broadcast band properly.
• Tune the frequency of the desired station.
-a
Interference. • Noise due to ignition noise from an automo­
bile.
• Noise due to interference from an electric
appliance
• Noise due to a nearby TV set
• Install the outdoor antenna away from the
road.
• Turn off the power to the appliance.
• Install the receiver farther away from the TV.
A station which was preset cannot be re­
ceived by pressing the corresponding nu­
meric key.
• The preset station belongs to a frequency that
cannot be received.
• The preset memory was cleared because the
power cord had been unplugged for a long
period of time
• Preset a station with a receivable frequency.
• Preset the station again
33 EN