Kenwood KRF-V5560D - Manual (Page 21)

Recording
Recording audio (analog murces)
Q
□□□□□
o
INPUT SELECTOR
Recording a music source
O Use the INPUT SELECTOR knob to select the source (other than
"MD/TAPE") you want to record.
@ Set the MD or TAPE recorder to record.
O Start playback, then start recording.
Recording video
O Press and hold the DIMMER key for more than 2 secondato select
the A-REC or M-REC mode.
• The mode changes every 2 seconds as shown below.
0 Rec mode off : The digital input record mode is switched
off.
( 2 ) A-REC : The digital input signals (DTS, Dolby
Digital, or PCM) are identified
automatically and converted into stereo
signals that are ready for recording.
0 M-REC ; The input signal type at the moment this
mode is selected is held throughout this
mode.
For A-REC mode:
'• $nKO
For M-REC mode:
O Use the INPUT SELECTOR to select the video source (other than
"VIDE01") you want to record.
Q Set the video deck connected to VIDEO 1 to record.
• Select the REC MODE to record a digital Input source.
O Start playback, then start recording.
• Recording may not be normal for some video software. This is due
to the copy guard condition. -¡3i
Recording audio (digital sources)
WGfr*L
: DNITAL
O Start playback, then start recording.
• If the audio reproduction stops in the middle due to change in the
input signals, etc., press the DIMMER key.
Switch on the REC MODE to record a digital input source.
Usually use the A-REC (Auto-Record) MODE to record audio input
sources. When the digital mode changes during recording in the A-REC
MODE , the audio input source may be interrupted momentarily.
Recording music in A-REC or M-REC mode
DIMMER
□
□
o
o
d
Lsoooo
SOO
INPUT SELECTOR
O Use the INPUT SELECTOR knob to select the source [CD/DVD,
DVD or DVD/6CH (VR-615/KRF-V5060D only) or VIDE02] you
want to record.
o Set the MD or TAPE recorder to record.
21 EN