Kenwood KR-V9020 - Manual (Page 34)

On-screen display
* T U N E R P R E S E T * *
1 K 1 K 1 8 K 1S S 1 5 K L M N
2 - - - - 9 - -- - 1 6 -----------------
3 - _ _ _ 1 0 - - ^ - 1 7 -----------------
4 - _ ^ ^ 1 1 W H Y Z 1 8 -----------------
5 - _ _ - 1 2 - - ^ - 1 9 -----------------
6
7 ^
1 3 - -
1 4 - -
- “ 2 0 --------------
SCREEN 4 (TUNER PRESET):
• Displays the contents of the tuner preset channels.
SCREEN 5 (ON SCREEN STANDBY):
• Shows the standby mode for the on-screen display.
The screen shown in the figure appears for 5 sec­
onds. then goes out.
• In this mode, when a relevant key is pressed, the
corresponding screen will be displayed for 5 sec­
onds, then go out,
3. SCREEN 6 (ON SCREEN OFF)
• Shows that the on-screen display is turned OFF.
When the power is switched ON, the figure shown on
the left will be displayed from 5 seconds, then go out.
• There is no on-screen display in this mode.
• Set to this mode when noise interferes with the video
picture.
* * T E S T T O N E * *
C E N T E R
L E F T % % R I G H T
% %
% % R E A R W//.
C E N T E R L E V E L + 8 D B
R E A R L E V E L + 1 2 D B
4, TEST TONE DISPLAY
• This screen appears when the TEST TONE mode is
engaged. The “ (darkened cursor) blinks at the
position where the test tone is being output.
Note: --------- ---------------------------------------------------------------------------------------------------------------------------- --------- -------------------
The position of the on-screen display (on the TV screen) may vary depending on the video software being played.