Remote control operation, Loading batteries into the remote control unit, Operations – Kenwood KR-V9020 User Manual
Page 35: Operating range of the remote control unit, Battery replacement
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Remote control operation
Loading batteries into the remote control
unit
Remove'the battery cover,
While gently pressing the battery cover located on the
rear of the remote control unit slide it in the direction
of the arrow,
2. Insert the provided batteries. Take care to respect the
battery polarity (-f, —).
\ _____ ^ j
R®
©W
H o
©9
H ©
H e
©1
I o
e
6
j
I
( )l
3, Be sure to close the cover after inserting.
control operations, Their service life may be short,
■ Operations
1. Connect the power plug of the receiver to an AC
outlet,
• The receiver enters the power standby mode and the
power standby indicator lights.
2. Press the POWER key of the remote control unit or the
POWER key of the receiver.
• The receiver enters the power ON mode.
3. The various functions of the receiver can be operated
with the keys of the remote control unit.
Note for remote control operation
After pressing one of the operation keys, when the next
operation is required, press the next operation key firmly after
an approx. 1 second interval.
If the next operation key is pressed immediately after the
previous key, misoperation may result,
■ Operating range of the remote control
unit
The operating range of the remote control unit may differ
according to temperature, humidity, or using conditions,
however, it is defined approximately as shown in the
figure below:
For controlling the receiver, TV and VCR
Remote control sensor of the
receiver, TV or VCR,
The signal transmission system
used by this remote control unit
is the infrared control system.
Battery replacement
If the TRANSMIT indicator wii! not light up when an
operation key is pressed, the batteries may be ex
hausted, In this case, replace them with new batteries,
It is recommended to use alkaline batteries (LR03 or
AM-4 type) with long life.
The programmed contents are not immediately lost
when the batteries are removed for replacement. How
ever, they could be lost if the unit is left without
batteries for more than 3 minutes. In such a case, the
programming should be performed again. The function
signals of the non-learning, or fixed, keys are not lost
even in this case.
Note: ------------------------------------------------------------------------------
Avoid using old and new batteries together, as this may
corrosion.
cause
Note: -----------------------------------------------------------------------------------------
Malfunction may occur in case direct sunlight or the light of a
high - frequency lighting fluorescent lamp enters the remote
control light recepter. In such a case, change the installation
position of the unit so that the malfunction does not occur.