Kenwood B60-0763-00 - Manual (Page 9)

75Q coaxial cable connection (For Europe)
® Arrange the coaxial cable as illustrated.
5 1 4 | a
(mm)
1
RG-6 (5C-2V) or RG-59 (3C-2VI
Open the antenna adaptor.
Open the claws with the fingers to
release the lock and pull out the cover.
Claw
Remove the inner conductor from the
groove of pole @ and insert it in the
groove of pole (|).
Pole @
Pole®
® Insert into the slit on the clip. Fasten the
bands A and B, using a pair of pliers.
Band A
Close the cover.
Band B
Connect the adaptor to the antenna
terminal.
FM DE-EMPHASIS/CHANNEL SPACE switch
(Except for some areas)
The FM DE-EMPHASIS/CHANNEL SPACE switch on the rear panel
is set to the correct setting that prevails in the area to which the
unit is shipped. However, if the FM DE-EMPHASIS/CHANNEL
SPACE setting is not matched to the area where the unit is to be
used; for instance, when you move from area 1 to area 2 or vice
versa, desired reception of AM/FM broadcasts is not expected. In
this case, change the FM DE-EMPHASIS/CHANNEL SPACE setting
in accordance with the area corresponding to the table. The FM
DE-EMPHASIS is switched over at the same time.
Area CHANNEL
SPACE freq.
FM DE­
EMPHASIS
1 U.S.A., Canada, and
South American
countries.
FM:100 kHz
AM ; 10 kHz 75 p s
2 Other countries FM ; 50 kHz
AM ; 9 kHz 50 p s
• When changing the setting of the FM DE-EMPHASIS/CHANNEL
SPACE switch, first disconnect the power cord, then reset the
channel space switch, connect the power cord again, and turn
the power on.
DE-
EMPHASIS
50 ys
75 ps s;
CHANNEL SPACE
AM FM
A 9 kHz
10 kHz
50 kHz
100 kHz
KR-V6040 (En)