Eq]: equalizer band select switches, High/low select switch, L__________________ y l j – Kenwood KRC-999II User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Controls and indicators (Control drawer section)
[EQ]: Equalizer band select switches
These switches are used to select the
equalizer band to be adjusted. Press
"<" to move the adjustable band (the
blinking indicator) to the left and press
" to move it to the right.
High/Low select switch
This switch IS used to select the operating
sensitivity, between High and Low, tor
the Auto Volume function.
is>i Ji-
c
AT
s
MTC
M
dbv
LO
mM
LO
pylTl.
l-D
Blank skip switch
[TUNER]: Local switch
With this switch ON, when a non-
When this switch is set ON, interference.
recorded blank section continues for
distortion, and noise in a strong signal
more than about 10 seconds, the tape is
area will be effectively reduced.
automatically fast-forwarded to the
beginning of the next tune.
L__________________y
L J
(Eni