Connections, Preamp output voltage selector (rear panel) – Kenwood KRC-999II User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Connections

■ Install the KRC-999U in a following manner and wiring them

1. Before installation and wiring, remove the ( —) terminal of the battery to prevent

short-circuiting.

2. Connect the ground to the metal chassis of the car.
3. Connect the input and output cords of the system.

4. Connect the back-up power supply lead (yellow).

5. Connect the accessory power lead (red).
6. Install the set and after confirming the installation and wirings are correct, connect

the ( — ) terminal of the battery.

7. After all installation and wiring are completed, be sure to press the Reset button.

Notes:-------- ------------------------------------------------------------------------------------------------------
When the fuse is blown, replace with a new one having the designated current capaci
ty after confirming that no cable is short-circuited.

■ Preamp output voltage selector (Rear panel)

High 1 V [ПШ] Normal 300 mV

(En)