Uniden UBC 120XLT - Manual (Page 22)

Searching
Thie UBC 120XLT can search bands you specify to fnd desired
frequencies if you do not have a Frequency Directory handy,
or if new stations have been added since the Directory was
published.
Press to stop scanning. 1,
2. Use the numeric keypad to enter the towesf frequency
of the range you want to search.
3. Press
4. Enter the highest frequency of the range you want to
search.
5. Press
6.
Press
| srch |.
During a Search, press (1^ to activate TURBO
SEARCH. This increases the Search Speed to 300
steps per second in those bands that have 5 KHz steps.
(See the table on page 3 for the Band Chart.) When
you activate TURBO SEARCH, the SRCH indicator
flashes. Press ( pT )again to deactivate TURBO
^ARCH.
7,
8
.
Press (H^j at any time to stop the search on a
frequency. Press [iitCHl again to resume searching.
When Search is stopped, you can press A or T to
move up or down 1 frequency step. (See the table on
page 3 for the step size of each Band.)
Using DATA Skip.
A scanner will normally stop on any transmission it receives. This
meansthe UBC120XLT willstopon Data signals and unmodulated
transmissions. You can skip these frequencies during Search,
Press (
dat
4^ to activate the DATA Skip feature. The DATA
indicator appears on the display. The scanner may pause
momentarily at an unwanted signal, but will resume searching
in 2 or 3 seconds. To deactivate DATA Skip, press
(
datj
^again. The DATA indicator disappears from the display.
Note: DATA Skip does not function on the AiR Band.
The DfffA indicator wili not appear on the display
even if this feature is activated.
20