Installing the belt clip, Using the earphone, Installing the belt clip using fhe earphone – Uniden UBC 120XLT User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Installing the Belt Clip

Place the Belt Clip on

the mounting area on

the back of the

scanner, making sure
the holes in the clip

line up with the

threads in the back of
the scanner.

2. Insert the 2 screws into the corresponding holes and

tighten.

CAUTION: Do not tighten the screws too tight. You could

damage the case or clip.

Using the Earphone

The PHONE jack at the top of the UBC 120XLT is a standard

3.5mm stereo phone jack. You can use either the supplied
earphone, ora stereo headset. The output of this jack is

monaural audio, but you will hear it in both headphones of a

stereo headset.

IMPORTANT!

Be sure to use only the supplied earphone, or stereo headset
of the proper impedance (32ÎÏ.) Use of an incorrect earphone
or stereo headset may be potentially dangerous to your
hearing.

WARNING:Do not plug in the earphone or head
phones before setting the Volume Control. You
might experience some hearing damage if the
Volume suddenly becomes too loud because of

the volume Control or Squelch Control setting.

This is particularly true of the type of earphone that
is placed in the ear canal.