beautypg.com

Scanning – Uniden UBC 120XLT User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Scanning

1.

2

.

Note: When you turn the scanner on it will always
be in SCAN Mode.

Look at the lower left corner of the display. If SCN is not

displayed, press @i. The UBC120XLT should begin
scanning.

If HOLD appears at the bottom of the display, press

@1

to begin scanning.

The indicators for the selected Banks (1 through 10) appear on

the display. The indicator of the Bank currently being

monitored flashes, While the UBC 120XLT is scanning, the

word SCAN moves across the display.

Scanning stops on any active channel that is not “Locked Out”,
and displays the Channel Number and frequency. Scanning
resumes automatically after the transmission stops.

3. You can deselect any bank(s) from being scanned by

entering the number of the bank. The deselected bank
indicator(s) disappear from the display, and those

channels will not be scanned. This procedure helps to

speed up the scanning cycle.

Note: One Bank must always be active. You cannot
deactivate alt 10 banks at the same time, if you try
to deactivate all 10 Banks, Bank 1 will automatically
be active.

4. To restore any bank for scanning, just enter its number

again. The bank indicator will reappear on the display.

5. To stop scanning any time, press @. (HOLD appears

on the display.) The scanner remains on the displayed

channel, and only the bank indicator for that channel

appears. Press to resume scanning.

6. When you are stopped at a channel, you can press ▼ to

step down a channel, or A to step up a channel. Press

and hold either key to rapidly step through the

channels.

Note: You do not skip a locked out f'UO") channel

when you use ▼ or A,

16