Uniden UBC 120XLT - Manual (Page 10)

4. Press (LIGHT) to turn the display backlight ON for 15
seconds. Press (UGKT) again to manually turn the light
OFF.
5. Use (V) to enter the decimal point when programming a
frequency into a channel. If you make an entry error,
press (J) key twice to erase the entry, and start over
again.
6. There are 7 Preprogrammed weather channels
Press ( WX ) to find the active weather channel in
your area. WX appears on the display in Weather Mode,
7. Use to set the limits of a range of frequencies for
Search Mode. When Search is stopped. In SCAN
HOLD Mode, use this key to go down to the next
channel. Use T to go down in frequency,
8 . While Scanning, press to enter the PRIORITY
SCAN Mode. (PRI appears on the display.) While
Searching, press (PRI ) (TURBO) to toggle between 100
steps and 300 steps per second. (When in TURBO
SEARCH Mode, SICH flashes on the display.)
9. Press (PEUf) to turn ON or OFF the automatic 2-second
delay during scanning or searching for active
frequencies. (In Delay Mode, DLY appears on the
display.) In this mode, when the scanner monitors an
active frequency, searching or scanning will not resume
until transmission stops for 2 seconds.
10. Press and ho/
you hear two beeps. This disables the keypad and
prevents any accidental key entries. To enable the
keypad, press and hold (
l
XK).
tt
* disappears from the
display and you hear two beeps.
11. NUMERIC KEYPAD — Use these keys to program a
channel for scanning. Also use to access a channel
directly with During SCAN Mode, use these keys to
select or deselect any of the 10 memory banks. (Only
the selected bank indicator(s) appear on the display.)
Note: You cannot deactiva te all 10 banks at the
same time.