Kenwood Preset Remote Control - Manual (Page 7)

; GéWng ìhé most from your remote comtqf;
Executing an^ To delete the setup code
iVIACRO
During opration, make sure you start the next step within 8
seconds of completing the previous one. if more than 8
seconds eiapses between any two steps, press the display
operation key so that the display appears.
•AiW
During opration, make sure you start thè next step within 8
seconds of completing the previous one. if more than 8
seconds eiapses between any two steps, press the display
operation key so that the display appears.
O Press the li^ACRO key.
• "t'lRCPD E>iE" appears in the display.
Q Press the display operation 1 key repeatedly until
‘tleni-i ” appears in the display.
MRCRO EKE
Seleci f'fl CRO
)
O Press the IMIUSIC, IldOVIE, or TV key to execute the
corresponding macro play.
»"f'fiCRiD EKE" appears in the display and the pre-programmed macro
is performed:
MUSIC "MFCRO 1", MOVIE "IlfiCRO 2", TV "MflCRO 3"
• Some devicestake up to 1 second to power on. The macro function
has an automatic delay after any power function output.
• Pressing a key other than MUSIC, MOVIE, or TV cancels the macro
program mode.
^ Press the [Menu] key repeatedly until 1-ji „ IF' ” appears
in the display.
o The setup display appears.
SEILJR
02. bJ,.r'rof.rd
Hopre a-Ttej-'
O Press the a /V keys to select ‘^I'l „ ” then press the
[Enter] key.
® The input selecting display appears.
S-03.UideQl
04.Video2
B-scii Enter'
vyhen MUSfC is pressed
O Press the a / w keys to select the input that you want to
delete, then press the [Enter] key.
O Press the a / v keys to select 'Delete. ”
S't33 Delete
01 5 CD
Bad< Ei-t,er'
O Press [Enter].
® The setup code is deleted.