Kenwood Preset Remote Control - Manual (Page 4)

■ Ш :::
0 Press the display operation 2 ¡Enter] key.
® The source selecting display appears,
* When you select “FTcriO" In step
E3. go to step E3.
sPi!5„ t.iCFt
66. Cable
Back Erii 0r
O Press the a / w keys to select the source you want to
register.
* Each time you press the A/v key, the input changes as follows:
> 01s CD
025 Т-эре>
63 s Г‘Ю
045 C1>R
0Ss UCR
06 s С.эЫе
075 Sate IИ i
00 s TU
095 • LD
10S DUD
il5 DSS (U.S.A
i'2s No t'dpe
^ 135 Delete
• Select "Ho type" when the desired source does not appear in the
display.
• The selected input does not appears when you select ‘'Delete."
1 ^ Press the display operation 2 [Enter] key.
• The maker selecting display appears.
For Europe and U.K For other countries
Г !
:-j^Keni'.ciCud is^Kenwood
Mptid'-ai
B.ac.k Ent.©!- [Back Enter-
© Press the a / w keys to select the maker you want to
register.
* Press the a / t keys until the desired maker appears in the display.
When the desired maker does not appear, select “HGti'd]-i9."
m
Press the display operation 2 [Enter] key.
« The setup code selecting display appears.
; 0gb6
02i htothirS
B.3.p^; Enter
Ш Press the a / w keys to select the setup code.
Ш Press the AV.POWER \/
component you want to control turns on.
и the component does not react, and there is more than one
setup code, enter another setup code and try again.
« or TUNING key can also be used instead of the A V. POWER i /Ф
key.
• if the component is already on, pressing the AV, POWER i/
will turn it off.
Press the display operation 2 [Enter] key.
“ The display returns to the setup display.
s-01 .IR
£12. Scrr-Ciund
Hopte &'iter-
Repeat steps B to Bio register additional components
until all components have been registered.
To returns to the initial display, press [Back] repeat­
edly until appears in the display.
t.fid&oi “
tiCR
¡■‘■ferii
' Once registered, the display on the receiver shows the component
type instead of the default input name.
Example: if you register a VCR at the VIDEO 1 jacks, "yideol" and
"liCR" appear in the display,
' Any VIDEO or TV (TV1, fV2, CABLE) inputs that have not been
programmed with a setup code or Non-IR code are deleted from the
cyclic list.
When you mistake
Press the display operation 1 [Back] key repeatedly until the display
you want to re-operate appears.
Note
Although each setup code is designed to work with a number of different
models, certain codes may not work with some models. {Aiso, certain
codes may only operate some of the functions available on a given
model.)