Kenwood Preset Remote Control - Manual

KENWOOD
'-iy: "7,' y '17 " - ' '' V' ”
- J w f ^ <
The remote control sends an RF (radio wave)
signal to the receiver. For equipment other than
the receiver, an IR (infrared) signal is sent.
For the operation of the RF remote function, see
page 14 and15 of the instruction of the unit.
Quick start guiiie ....... .............................................. 1
Getting the most from your remote controi ................... 3
Gemote operation of other components ..................... 11
in case of difficulty .................................................. 14
This quick start guide explains how to setup the remote
control to operate audio and video components other
than the receiver.
in order to make full use of the functions of the remote
control, be sure to read the section of this manual
entitled “Getting the most from your remote control”.
It contains a detailed explanation of how to operate the
remote control and make the necessary settings.
The quick start guide describes the operation of the
following keys:
O Display operation 1 key
Use this key to go back to the previous display or initial
display.
@ Display operation 2 key
Gets you into and out of the preset code registration
mode.
® Display
The information for setup is displayed.
® A/Tkeys
Use these keys to select the source or setup code.
® MUSIC, MOVIE, and TV keys
Use these keys to select the input you want to register.
0 AV.POWER i/ci) key
Once you have entered the setup code for another
component, you can press this key to turn power to that
component on or off. This lets you confirm that you
entered the code properly.
B60-4608-00 01 C® (K, P) rx¥; 9911