Kenwood TS-430S - Manual (Page 15)

• M.CH (Memory channel) operation
The TS-430S has eight memory channels. The memory
permits input of both frequency and mode, and this data
will be permanently retained (by the built-in lithium bat­
tery).
1. The M.CH switch selects the desired channel from CH
1
-
8
.
2. When the M.IN switch is depressed, a "beep" sounds,
indicating memory input.
3. There are two recall modes for memory channel con­
tents.
* Depress the M.CH switch. Any one of eight channels
can be selected by the M.CH switch as a fixed (non-
tunable) frequency and mode.
* Depress the MR switch. The channel designated by
the M.CH switch is recalled to the VFO for tunable oper­
ation. The memory contents are not changed.
These switches are for
recalling memory.
• Memory scan operation
1. Input frequencies and modes to be scanned into the
memory channels.
2. Depress the MS switch. The channel number and fre­
quency of each occupied channel is displayed. Scan in­
terval is approximately 1.8 seconds per channel.
3. When the desired traffic is received during scan, de­
press the HOLD switch.
4. Scan will resume by releasing the HOLD switch.
NOTES: ------------------------------------------------------------------------------
1. The channel eight transmit frequency is not scanned.
2. When memories are empty, is displayed and there is
no scan.
3. Scan is held by transmitting, and resumes when the
transceiver returns to the receive mode.
( 2 ) Depress to initiate memory scan.
15