Genie Excelerator - Manual (Page 29)

C5eri
Li'Oblc.iV; What To Do
Remote Control has less
«
Relocate Remote Control inside car.
than 25'operating range
«
«
«
«
Ensure Remote Control is pointing toward garage door when pressing Control Button.
Replace Remote Control Battery
^EVEREJWY, type"A23." (See page 22).
Reposition Opener Antenna Wire.
Do Not attempt to retune Remote Controls or Receiver.
Opener works from Wall
Control, but not from
: «
Program code for each Remote Control into Receiver memory (See Programming the Remote
Control on page 22.
Remote Control
: «
: «
: «
Replace Remote Control Battery ^jtEVERERDY, type"A23." (See page 22).
Check Safe-T-Beam® System for beam obstruction or misalignment of Lenses.
Check Safe-T-Beam® System for any diagnostic codes. If present, troubleshoot as detailed in
Safe-T-Beam® System Self-Diagnostic Troubleshooting Chart (See page 26).
Noisy operation i
«
•
e
Ensure all fasteners are tightened.
Check that the garage door and Opener are in good repair, properly lubricated,and properly j
balanced. (See Maintenance page 25).
i
: If you suspect a problem with garage door hardware or springs, contact a Genie
Factory Authorized Dealer for service, or contact Customer Service at 1-800-35-GENIE.
Safe-T-Beam® System
% «
«
£ «
If an operational problem exists, Opener will not run closed.
Check Safe-T-Beam® System for beam obstruction or misalignment of Lenses.
Check Safe-T-Beam® System for any diagnostic codes. If present, troubleshoot as detailed in Safe-T-Beam®
System Self-DiagnosticTroubleshooting Chart (See page 26).
Door closes, and Opener
£ «
Check position ofWall Console Vacation Lock Switch. It must be in UNLOCKED position for Opener to
1
shuts down open door.
SECONDARY GROUND
FcM' Help, call IHIOOHJSHSEiiE or ¥islt i«%wi.ferileccirnpiirif.corn 29