Genie Excelerator - Manual (Page 22)

A To program one Button of a Remote Control (Figure 37):
• Locate Learn Button and Learn Indicator Light near
Terminal Block on Power Head (Figure 38).
• Press and release Learn Button. Red Learn Indicator Light
will blink 2 times per second.
• Press Remote Control Button once within 30 seconds.
Red Learn Indicator Light will stay lit.
• Press Remote Control Button again. Red Learn Indicator
Light will go out, indicating that memory is stored.
B Program each additional Remote using step A above.
To Erase All ieiricites froiri Power H
A Press and hold Learn Button on Power Head for 10 seconds or
until Learn Indicator Light goes out. Memory is erased:
• Program Remotes again as needed.
To ieplacts ierriote Control iattery
A Push in on Battery Cover Latch at base of Remote Control
(Figure 39):
• Use coin, pen, screwdriver or any similar device.
- Cover snaps open.
• Replace old Battery with new ^EVEREAD% A23,
12 Volt Battery.
B Snap Battery Cover closed.
A
WARNING
A moving garage door may cause serious injury or death.
• Keep people clear of opening while door is moving.
• Do not allow children to play with the Remote Controls.
If the Safety Reverse does not work properly:
• Close the door and disconnect the Opener using the
Emergency Release Cord.
• Do not use the door Opener, Remote Controls, or
Wireless Keypad.
• Refer to the door and door Opener Owner's Manuals
before attempting any repairs.
Press Button on Remote Control. Garage door will move.
Press Button again. Garage door will stop:
• The door automatically stops at the end of the open or
close cycle.
Press Button again. Garage door will reverse.
NOTE
Each Remote Control must be programmed
separately.
The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning.
When programming the Remote Controls, they
must be at least 24'Arom the Antenna Wire.
If the red Learn Indicator Light blinks
approximately 4 times per second,
programming has stopped. If programming
has stopped, repeat the above steps.
Each Button on a 2 or 3 Button Remote Control
is for a different Opener. You cannot use more
than one Button per Remote, per Opener.
A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see "To Erase All
Receiver Memory."
05
1 Button
Remote
2 Button
Remote
3 Button
Remote
48
Figure 37 Genie Remote Controls
Figure 38 Learn Code Button and Indicator Light
.... Visor Clip
Push to open
Battery Cover
Model
Number
I
iiJO'
Figure 39 Remote Control Battery Replacement
22 FcM' Help, call 1-SOOHJS4SEÌÌE or visit www.gBmstompsmi.mm